Sterile Water for Injection
$6 – $15
|Generic Drugs||Sterile Water|
|Manufacturer||Sun Pharmaceutical Industries Ltd|
|Pack Size||Price||Price Per Unit||Qty||Add To Cart|
|30 Ampoule S||$15||$0.50|
|20 Ampoule S||$10||$0.50|
|10 Ampoule S||$6||$0.60|
Sterile Water for Injection
Sterile Water for Injection, USP, is sterile, nonpyrogenic, distilled water in a single dose container for intravenous administration after addition of a suitable solute. It may also be used as a dispensing container for diluent use. No antimicrobial or other substance has been added. The pH is 5.5 (5.0 to 7.0). The osmolarity is 0.
Drug = Sterile Water
Strength =10 ml
Menufacture =Sun Pharma
How to Take
Your doctor or nurse will give you injection. Kindly do not self administer.
Following suitable admixture of prescribed additives, the dosage is usually dependent upon the age, weight and clinical condition of the patient as well as laboratory determinations. See directions accompanying additive drug.
Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration whenever solution and container permit.
Injections in plastic containers are intended for intravenous administration using sterile equipment.
Additives may be incompatible. Complete information is not available. Those additives known to be incompatible should not be used. Consult with pharmacist, if available. If, in the informed judgment of the physician, it is deemed advisable to introduce additives, use aseptic technique.
Do not store an unused portion of Sterile Water for Injection, USP. Mix thoroughly when additives have been introduced. Do not store solutions containing additives.
The administration of a suitable admixture of prescribed additives may be associated with adverse reactions because of the solution or the technique of administration including febrile response, infection at the site of injection, venous thrombosis or phlebitis extending from the site of injection, extravasation, and hypervolemia.
If an adverse reaction does occur, discontinue the infusion, evaluate the patient, institute appropriate therapeutic countermeasures, and save the remainder of the fluid for examination if deemed necessary.
Do not administer unless solution is clear and seal is intact.
General = Do not use for intravenous injection unless the osmolar concentration of additives results in an approximate isotonic admixture.
Consult the manufacturer’s instructions for choice of vehicle, appropriate dilution or volume for dissolving the drugs to be injected, including the route and rate of injection.
Inspect reconstituted (diluted or dissolved) drugs for clarity (if soluble) and freedom from unexpected precipitation or discoloration prior to administration.
Drug Interactions = Some drugs for injection may be incompatible in a given vehicle, or when combined in the same vehicle. Consult with pharmacist, if available.
Pregnancy Category C = Animal reproduction studies have not been conducted with Sterile Water for Injection. It is also not known whether Sterile Water for Injection can cause fetal harm when administered to a pregnant woman or can affect reproduction capacity. Sterile Water for Injection should be given to a pregnant woman only if clearly needed.
Pediatric Use = The safety and effectiveness in the pediatric population are based on the similarity of the clinical conditions of the pediatric and adult populations. In neonates or very small infants the volume of fluid may affect fluid and electrolyte balance.
The plastic container is fabricated from a specially formulated polyvinyl chloride (PL 146 Plastic). The amount of water that can permeate from inside the container into the overwrap is insufficient to affect the solution significantly. Solutions in contact with the plastic container may leach out certain chemical components from the plastic in very small amounts; however, biological testing was supportive of the safety of the plastic container materials.